Thermador Pro Grand PRD364JDGC Installation Manual page 13

Dual fuel ranges
Hide thumbs Also See for Pro Grand PRD364JDGC:
Table of Contents

Advertisement

Available languages

Available languages

Due to the weight, it is strongly recommended that a
furniture dolly with soft wheels or an air lift should be used
to move this unit. The weight must be supported uniformly
across the bottom.
All ranges are held to the pallet by (4) bolts through a wood
block center. The two front pallet bolts are accessible only
after removing the Door Trim located beneath the doors.
1. Remove the door trim by loosening the 2 Torx screws
attaching it to the range. Slide the trim up and off the
screws.
2. To remove the pallet bolts use (2) ½" (13 mm)
wrenches, one to hold bolt at the bottom while the other
is loosening the nut at the top. Discard the wood
packing block inserts.
Figure 7: Removal of Shipping Bolts
English 10
Figure 6: Door Trim Removal
3. PRDS48JDSGU/C models: To access the pallet bolt
located beneath the warming drawer, reach up and
behind the frame of the unit with one 1/2" wrench to
hold the nut at the top (see Figure 8). Use the second
wrench to loosen the bolt at the bottom. DO NOT
remove the warming drawer.
Figure 8: Removal of Bolts Beneath Warming Drawer
4. Carefully tilt the range back and remove it from the
pallet. Use additional help as required to remove from
pallet.
5. After transporting the range by furniture dolly close to
its final location, the range can then be tipped back
while the dolly is carefully removed.
6. THE FLOOR UNDER THE LEGS SHOULD BE
PROTECTED BEFORE PUSHING THE UNIT INTO
POSITION.
Steps 5 through 8 must be completed before the
range is placed in its final position.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents