Sanyo SAP-KRV91EH Technical & Service Manual page 79

How to replace the
anti-mold filter
Air Clean Filter
How to install the air clean
Cleaning the main unit and
remote control unit
OI-275-33EG
Care and Cleaning (continued)
1. With the ''FRONT'' mark
facing you, slide the
anti-mold filter up into the
unit and then lower the
handle into the groove on
the unit.
2. After installing the
anti-mold filter, press the
locations marked by the
arrows (
air intake grille.
The air cleaning filter removes
dust and dirt from the air, and
reduces odors and smoke from
tobacco.
The air clean filter is included
with the unit when shipped
from the factory. When
changing the filter subsequently, it is only necessary to replace the filter
itself (model STK-F4B).
This air clean filter cannot remove harmful gases or vapors nor ventilate
air in the room. You must open doors or windows frequently when you
use gas or oil heating appliances. Otherwise there is a risk of
suffocation in extreme cases.
The air clean filter needs to be
filter
installed behind the anti-mold
filter.
1. Remove the anti-mold filter.
2. Install the air clean filter in
the position shown in the
diagram, with the
'' '' symbols (meaning
''FRONT'') facing the front.
3. Reinstall the anti-mold filter.
Wipe clean using a soft, dry cloth.
•
To remove stubborn dirt, moisten a cloth in warm water no hotter
•
than 40 °C, wring thoroughly, and then wipe.
The air intake grille can be removed in order to wash it with water.
•
) and close the
Anti-mold
filter
Air
clean
filter
Air intake grille
Insert into the groove on
the unit.
33