Before Operation (Remote Control Unit) - Sanyo SAP-KRV91EH Technical & Service Manual

Setting the Current Time
Mounting the Remote
Control Unit
When Holding the Remote
Control Unit
OI-275-15EG
Before Operation
(Remote Control Unit)
Example: Setting to 10:10 AM
Press so that 0:00 PM is displayed.
(To correct the current time during air conditioner operation, press
. The clock display flashes.)
1. Use the and buttons to set the time to 10:10 AM.
The time can be set in 1-minute units. Holding down the button
changes the time in 10-minute units.
2. Press .
This sets the current time.
Before mounting the remote control unit, press the
mounting location to make sure that the air conditioner operates from
that location. The indoor unit should make a beeping sound to indicate
that it has received the signal.
Mounting screws
4 x 16 (included)
Remote control
unit mount
To take out the remote control unit, pull it forward.
When using the remote control unit and during air conditioner
•
operation, the transmitter on the remote control unit should be
pointed toward the receiver on the indoor unit.
Make sure that there are no objects between the remote control unit
•
and receiver which could block the signal.
STEP 1
STEP 2
button at the
Press
2
Set in
place
1
15