Power Button Board - HP EliteBook 725 G2 Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
e. System board (see
Remove the power button board:
1. Remove the two Phillips PM2.0×3.25 screws (1) that secure the power button board to the top cover.
2. Remove the power button board (2) and cable.
Reverse this procedure to install the power button board.
Service cover on page
Battery on page 40)
Hard drive on page 42)
Keyboard on page 52)
Top cover on page 58)
System board on page
38), and then remove the following components:
75)
Component replacement procedures
Spare part number
730552-001
83