Fingerprint Reader Board - HP EliteBook 725 G2 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes bracket and cable)
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
Remove the fingerprint reader board:
1. Turn the top cover upside down with the front toward you.
2. Detach the fingerprint reader board cable (1) from the top cover. (The fingerprint reader board cable is
attached to the top cover with double-sided adhesive.)
3. Remove the three Phillips PM2.0×2.5 screws that secure the fingerprint reader board and bracket to the
top cover.
4. Remove the fingerprint reader board bracket (3).
80 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service cover on page
Battery on page 40)
Hard drive on page 42)
Keyboard on page 52)
Top cover on page 58)
38), and then remove the following components:
Spare part number
730554-001