Display Assembly - HP EliteBook 725 G2 Maintenance And Service Manual

Display assembly

NOTE: The TouchScreen display assembly is spared as a whole unit replacement. The non-TouchScreen
display assembly is spared at the subcomponent level only. For more display assembly spare part
information, see the individual removal subsections.
Description
12.5-in, AntiGlare, FHD, LED, UWVA, TouchScreen display assembly
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
Remove the display assembly:
1. Release the display panel cable from the routing clips (1) and channel built into the base enclosure.
2. Release the wireless antenna cables from the routing clips (2) and channel built into the base enclosure.
3. Remove the four Phillips PM2.5×4.5 screws (1) that secure the display assembly to the base enclosure.
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service cover on page
Battery on page 40)
Hard drive on page 42)
Keyboard on page 52)
Top cover on page 58)
38), and then remove the following components:
Spare part number
765606-001