Speaker Assembly - HP EliteBook 725 G2 Maintenance And Service Manual

5. Remove the fingerprint reader board (4).
Reverse this procedure to install the fingerprint reader board.

Speaker assembly

Description
Speaker assembly (includes left and right speakers and cables)
Before removing the speaker assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
e. System board (see
Remove the speaker assembly:
1. Release the four clips (1) built into the top cover that secure the speaker assembly to the top cover.
Service cover on page
Battery on page 40)
Hard drive on page 42)
Keyboard on page 52)
Top cover on page 58)
System board on page
38), and then remove the following components:
75)
Component replacement procedures
Spare part number
730555-001
81