Card Reader Board - HP EliteBook 725 G2 Maintenance And Service Manual

Card reader board

Description
Card reader board "non-gold" (includes cable)
Card reader board "gold" (includes cable)
Before removing the card reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the service cover (see
a. Battery (see
b. Hard drive (see
c. Keyboard (see
d. Top cover (see
Remove the card reader board:
1. Turn the top cover upside down with the front toward you.
2. Release the ZIF connector (1) to which the card reader board cable is attached, and then disconnect the
card reader board cable (2) from the system board.
3. Turn the top cover upside down with the front toward you.
4. Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the card reader board.
5. Release the card reader board cable (2) through the opening in the top cover.
Service cover on page
Battery on page 40)
Hard drive on page 42)
Keyboard on page 52)
Top cover on page 58)
38), and then remove the following components:
Component replacement procedures
Spare part number
730563-001
802504-001
69