Fingerprint Reader Board - HP EliteBook 630 Maintenance And Service Manual

Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad:
1. Disconnect the system board cable from the ZIF connector on the touchpad (1).
2. Lift the tape off the top of the touchpad (2).
3. Release the keyboard backlight cable from the adhesive that secures it to the top of the touchpad (3).
4. Remove the four Phillips M2.0× 2.0 screws (4) that secure the touchpad to the computer.
5. Remove the two Phillips M1.6 × 2.0 screws (5) that secure the touchpad to the computer.
6. Remove the touchpad from the computer (6).
NOTE:
NFC module. The antenna is secured to the touchpad.
Reverse this procedure to install the touchpad.

Fingerprint reader board

To remove the fingerprint reader board, use this procedure and illustration.
Table 6-6 Fingerprint reader board description and part number
Description
Fingerprint reader board
Fingerprint reader board cable (included in Cable Kit)
Bottom cover on page
Battery on page
If an NFC module is installed, disconnect the NFC antenna cable from the ZIF connector on the
Preparation for disassembly on page
37).
44).
37).
Spare part number
N00879-001
N00097-001
Fingerprint reader board 49