Table of Contents
Advertisement
Card reader board
Table 6-9
Card reader board and cable descriptions and part numbers
Description
Card reader board assembly (includes cable)
NOTE:
The card reader board cable is also available in the Cable Kit as spare part number L52208-001.
Before removing the card reader board, follow these steps:
1.
Prepare the computer for disassembly
2.
Place the computer in Battery Safe mode
3.
Remove the bottom cover
4.
Remove the battery
Remove the card reader board:
1.
Remove the two Phillips M2.0 × 2.0 screws (1) that secure the card reader board to the computer.
2.
Remove the tape from the cable (2).
3.
Position the board upside down so you can access the connectors underneath (3).
4.
Disconnect the RTC battery from the card reader board (1).
5.
Disconnect the card reader board cable from the card reader board ZIF connector (2).
(Preparation for disassembly on page
(Battery Safe mode on page
(Bottom cover on page
(Battery on page
41).
32).
33).
Component replacement procedures
Spare part number
L52223-001
32).
51
Advertisement
Table of Contents
