Waypoint Configuration (Software Version 4.00 Or Later) - Garmin GTN 625 Installation Manual

6.6.14

Waypoint Configuration (software version 4.00 or later)

Access the Waypoint Configuration page, shown in Figure 6-26, by touching the 'Waypoints' key from the
GTN Setup page. This page allows you to configure settings related to user defined waypoints.
Mark on Target (Heading)
This selection allows you to configure the GTN for the use of the mark on target function.
Selection
Disabled (default)
Enabled
190-01004-02
Rev. F
Figure 6-26. Waypoint Configuration Page
Description
Additional user interface for handling mark on target waypoints will not be
present. This is applicable to installations that do not have the MARK ON
TARGET* discrete input connected.
Additional user interface for handling mark on target waypoints will be
present. This is applicable to installations that have the MARK ON TARGET*
discrete input connected.
GTN 625/635/650 TSO Installation Manual
Page 6-27