Hsdb (Ethernet) Configuration Page; Interfaced Equipment Page - Garmin GTN 625 Installation Manual

GTN Selection
Panel GTX w/TIS #1
Panel GTX w/TIS+ #1
Panel GTX w/TIS #2
Panel GTX w/TIS+ #2
Traffic Format 7
Traffic Format 8
6.6.3 HSDB (Ethernet) Configuration
Page
Access the HSDB Ethernet page, as shown in
Figure 6-6, by touching the 'HDSB (Ethernet)' key
on the GTN Setup page. Touch the key next to the
port to configure it as 'Connected' or 'Not
Connected'. If a Garmin LRU is connected to a
specific Ethernet port, then configure the port as
'Connected'. If no LRU is connected to the port,
configure it as 'Not Connected.'
6.6.4

Interfaced Equipment Page

Access the Interfaced Equipment page, as shown in
Figure 6-7, by touching the 'Interfaced Equipment'
key on the GTN Setup page. This page allows the
configuration of the presence of a Cross-Side
Navigator, GDL 69/69A, GDL 88, Transponder #1,
Transponder #2, and GSR 56.
190-01004-02
Rev. F
GNS Equivalent Description
Select this format for the GTX 330/330ES transponder #1.
N/A This provides ground speed, GPS PVT, and pressure
altitude information to the transponder.
Control of GTX 33ES/330ES #1 transponder functions,
pressure altitude data, groundspeed data, and TIS traffic.
N/A
For use with GTX software version 7.00 or later for AC 20-
165 compliance.
Select this format for the GTX 330/330ES transponder #2.
N/A This provides ground speed, GPS PVT, and pressure
altitude information to the transponder.
Select this format for the GTX 330ES transponder #2. This
provides groundspeed, GPS PVT, and pressure altitude
N/A information to the transponder without controlling the
transponder via the GTN. For use with GTX software
version 7.00 or later for AC 20-165 compliance.
Select this format for the Ryan TCAD 9900B Series traffic
Ryan TCAD
system.
Select this format for the Ryan TCAD 9900BX Series traffic
Ryan TCAD
system.
Figure 6-6. HSDB Port Utilization Page
Figure 6-7. Interfaced Equipment Page
GTN 625/635/650 TSO Installation Manual
Page 6-11