System Information Page; Arinc 429 Configuration Page - Garmin GTN 625 Installation Manual

6.5 System Information Page

Access the System Information page, as
shown in Figure 6-2, from the Configuration
Mode page by touching 'System Information'
key.
The System Information page displays the unit
type, serial number, and system ID for the
GTN. It also contains the software and
hardware versions of the Main, I/O, Display,
Keypad, LED, GPS/WAAS, and NAV boards.
This information is also available for certain
other LRUs connected to the GTN. Touch the Figure 6-2. System Information Page
'GTN' key and choose what LRU to display.
Touch 'UP' or 'DOWN' to view all the
information.
6.6 GTN Setup Page
The following sections describe pages that are accessed from the GTN Setup page, as shown in 
Figure 6-3. To access the GTN Setup page, touch the 'GTN Setup' key from the Configuration Mode page.
Figure 6-3. GTN Setup Page
6.6.1

ARINC 429 Configuration Page

Access the ARINC 429 Configuration page, as
shown in Figure 6-4, by touching the 'ARINC
429' key on the GTN Setup page. This page
configures the two ARINC 429 input ports and
the two ARINC 429 output ports. Select the
correct speed for each port depending upon the
installed interfaced equipment by touching the
speed key and toggling the high or low selection.
Select the correct Data In and Data Out settings
Figure 6-4. ARINC 429 Configuration Page
for each port. Touch the 'UP' or 'DOWN' key to
scroll through the ARINC selections. The data
selections are described in the following table.
190-01004-02 GTN 625/635/650 TSO Installation Manual
Rev. F Page 6-3