Hsdb (Ethernet) Configuration Page; Interface Equipment Page; Figure 5-5. Hsdb Ethernet Port Configuration Page - Garmin GTN 725 Installation Manual
Hide thumbs
Also See for GTN 725:
- Pilot's manual (554 pages) ,
- Cockpit reference manual (112 pages) ,
- Reference manual (110 pages)
Table of Contents
Advertisement
5.4.3
HSDB (Ethernet) Configuration Page
The HSDB Ethernet page can be accessed from the GTN
Setup page. Touch the button next to the port to configure it
as 'Connected' or 'Not Connected'. See Figure 5-5. If a
Garmin LRU is connected to a specific Ethernet port, then
configure the port as 'Connected'. If no LRU is connected
to the port, configure it as 'Not Connected'.
5.4.4
Interface Equipment Page
Touch the Interface Equipment button on the GTN Setup page.
This page allows the configuration of the presence of a cross-side
navigator, GDL 69/69A, Transponder #1 and Transponder #2.
Page 5-8
Rev. A
Figure 5-5. HSDB Ethernet Port Configuration
Page
Figure 5-6. Interfaced Equipment Page
GTN 725/750 TSO Installation Manual
190-01007-02
Advertisement
Table of Contents
