Installation On A Fixed Flat Surface; Inserting Batteries Into The Remote Control - Kathrein UFS 946/CI+ Operating Instructions Manual

So as to prevent the receiver slipping or
falling, the mounting kit can also be attached
to the underside of the receiver. Assembly
is the same as for suspended installation,
except that the mounting kit is attached to the
underside of the receiver.
Remove the cover on the rear of the remote control. Insert the two batteries supplied into the remote
control. Ensure correct polarity of the batteries; the + and – markings are indicated inside the battery
compartment. Slide the cover back onto the housing until it locks in place.
Connection and set-up
Installation on a fi xed fl at surface

Inserting batteries into the remote control

To open:
Gently press here and pull
backwards
9