Kathrein UFS 946/CI+ Operating Instructions Manual page 23

On the "Satellite" line select the satellite whose settings you wish to edit.
Satellite:
Select the desired satellite using the
view a list of all satellites which you have previously selected, then select the required satellites from
this list.
LNB Type:
If your reception system does not have a universal LNB, use the
that are used in your reception system. You can choose from the following LNB types:
- Universal
- Simple or
- User-defi ned
If you do not use a Universal LNB, press the
LNB type (simple or user-defi ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the
new values.
Test-Transponder:
Select the "Test-Transponder" fi eld. Here you can select a transponder for checking whether your
settings are correct using the signal strength bar and signal quality bar.
Stop on Signal:
Select the selection fi eld "Stop on Signal". Here, you can select whether the turntable antenna should
stop its rotary movement immediately on reception of a signal from the desired satellite. You can choose
between "On" and "Off".
Move Antenna:
Select the selection fi eld "Move Antenna". Here you can control the movements of the motorised
antenna, using the following buttons:

Start slow rotation to West

Rotate to the West step by step

Stop the current movement
Connection and set-up

buttons. Alternatively you can press the

button. You can now defi ne the settings for your

buttons to select the LNB types
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.


button to
button to save the
23