Kathrein UFS 946/CI+ Operating Instructions Manual page 17

- Universal
- Simple or
- User-defi ned
If you do not use a Universal LNB, press the
(simple or user-defi ned).
LNB Frequencies (MHz):
Enter the LNB frequencies (Low/High/Limit) using the number pad. Now use the
new values.
DiSEqC™ Repeat:
The setting for how often the DiSEqC™ command must be repeated depends on the confi guration of your
reception system.
- Off DiSEqC™ command is not repeated
- 1 DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice
- 3 DiSEqC™ command is repeated three times
Test-Transponder:
Select the "Test-Transponder" fi eld. Here you can select a transponder for checking whether your
settings are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the
If you have selected more than one satellite (four max.) for Tuner 1, you can now defi ne the settings
as described above for the fi rst satellite, for the second satellite and then for the third and fourth
satellites, if selected.
When you have completed all settings for the tuner, press the
The receiver will automatically display the screen for the channel search. Continue the fi rst installation
with the "Channel search" section.
Connection and set-up

button. You can now defi ne the settings for your LNB type
Refer to the documentation for
your LNB or seek assistance
from a specialist engineer.

Refer to the documentation for
your reception system or seek
assistance from a specialist
engineer.

button.

(green) button.
button to save the
17