Suspended Installation (Example) - Kathrein UFS 946/CI+ Operating Instructions Manual

Remove the wood screws supplied from their transport attachment on the top of the respective mounting
piece (2 pieces).
Place the two mounting pieces on your
receiver as shown in Figures 1-3. During
the process the following should be
taken into account:
1. Left (L) and Right (R) markings (see
arrows Figure 2)
2. The teeth on the underside of the
mounting pieces must be inserted in
the fi rst and last row of the ventilation
slots on the top of the receiver (see
arrows Figure 1)
Now hold the receiver, with the installation kit attached, at
the installation location. Screw in the wood screws supplied
through the smaller holes in the screw attachment area (4 x)
(see Fig. 4). Wherever possible, use the wood screws supplied.
If these are unsuitable, other screws of adequate size and
strength can be used. Under no circumstances however
use countersunk wood screws, since these can damage
the attachment area (see Fig. 5).
Then screw all four screws fully home, so that the installation
kit is no longer able to come free.
For subsequent disassembly it is suffi cient to undo all screws one turn each and
to push the receiver to the right (suspended) or left (on top) to release it.
8
Connection and set-up

Suspended installation (example)


↓
↓
↓
↓
↓
↓
↓
↓
↓
Screw attachment
left right



