Kathrein UFS 946/CI+ Operating Instructions Manual page 13


Press the (green) button to move to the next menu.
The following on-screen display appears:

Use the buttons here to select the basic
settings for the video and audio output of the
receiver to the TV set.
For this, refer to the operating
instructions for your TV set and
take care to select only those
settings that your TV set can
process.
Video Output via
The rear panel outputs video via the HDMI socket on the unit's rear panel.
HDMI/YPbPr Resolution
Here you can select the video resolution that will be output at the TV set. Either
- 1080p (resolution 1920 x 1080, full-screen images)
- 1080i (resolution 1920 x 1080, half-screen images)
- 720p (resolution 1280 x 720, full-screen images)
- 576p (resolution 720 x 576, full-screen images) or
- Automatic
Force 576i (must be supported by the TV set otherwise you will not see a TV picture)
You can only and need only make this setting if you have selected the setting "Automatic" for "HDMI/
YPbPr Resolution". If for a programme that is transmitted in the format 720 x 576 (standard TV),
the original format is to be transmitted to the TV set, select the "On" setting. If the setting is "Off",
the programme may be automatically scaled up to the HDTV format 720p by the receiver.
HDCP for free channels
Select here whether HDCP (digital copy protection) is to be constantly set to "On" with free channels or
is not to be activated, "Off".
TV control box via HDMI (CEC)
If you select "Off", the TV set must be switched on or off separately. If you select "On", the TV set will
be switched on automatically as the receiver starts up (but only if the TV set was in standby mode).
If the receiver is switched off into standby mode, the TV set will also be switched to standby mode.
Automatically simultaneously switching the TV set on/off by the receiver is available only if the TV set
supports this function!
Connection and set-up
13