Troubleshooting - Kathrein UFS 946/CI+ Operating Instructions Manual

In the event of a malfunction, fi rst check all the cable connections and operating states:
1. Receiver and TV set power plugs are connected to wall socket
2. Antenna cables are connected to the receiver input
3. Receiver and TV set correctly connected by a HDMI or Scart cable
4. Audio connections are made to the Hi-Fi or Dolby Digital system as appropriate
5. Receiver and TV set (Hi-Fi/Dolby Digital system) are switched on (check power indicators)
6. Receiver is responding to remote control
A selection of troubleshooting tips is offered below.
Problem
A "No signal!" warning
appears on some
or all channels
Receiver no longer
responds to the
remote control
Wrong time is displayed
The following channels
cut out or "No or bad
signal!" appears:
Sport 1, Tele 5, HSE 24
and Sonnenklar TV

Troubleshooting

Cause
The batteries may
inserted incorrectly in the battery
compartment
Receiver or remote
command set may
unintentionally changed
"Summertime" setting wrong. An
incorrect time was imported from
the reception signal
DECT telephones operate on the
same frequency as these channels.
Interference may occur due to
inadequate output level or poor
shielding of cable
Consult an antenna specialist to
have it checked and repaired as
necessary.
made in the "Settings", "Antenna
& Satellite", "Tuner Confi guration"
menu, and change them if necessary.
Check
be fl at or
"Inserting batteries into the remote
control" in the Operating Instructions
– Part 1)
Set infra-red code 1 as described
control
in these
have been
under "Mainmenu settings", "Basic
Settings", "Remote Control Code"
Under "Settings", "Basic Settings",
"Time Setting" in the menu, check
the set time deviation to UTC and
change as necessary. Use the
power switch to switch the receiver
off from the current channel, e.g.
Das Erste or ZDF, wait 10 seconds
and then switch it back on
Consult your antenna specialist
Remedy
Check the settings
the batteries (see
operating instructions
also
47