Kathrein UFS 946/CI+ Operating Instructions Manual page 31

Connection and set-up
Satellite:
 
Select the desired satellite using the buttons. Alternatively you can press the button to
view a list of all stored satellites then select the required satellites from this list.
Transponder Frequency:
 
Select the desired transponder using the buttons. Alternatively you can press the button
to view a list of all transponders stored for this satellite and then select the required transponder from
this list.
Test Ton:
Using the test tone you can have the unit output a tone via the TV set to assist with the alignment of

the mobile antenna. Select the required setting using the buttons:
- On: The nearer the actual value is to the required value, the higher the tone becomes
- Automatic: You only hear a tone once the actual value is the same as the required value
- Off: You will not hear any tone
You can check whether your settings are correct using the signal strength bar and signal quality bar.

When you have completed all settings, press the (green) button.
The receiver will automatically display the screen for the channel search. Continue the fi rst installation
with the "Channel search" section.
31