Adjustments; Height Of Cut Adjustment; Handle (Walk Behind Machine Only) - Ransomes Mastiff 91 Safety, Operation & Maintenance Manual

7 ADJUSTMENTS

7.1 HEIGHT OF CUT ADJUSTMENT __________________________________________

The cutting height is determined by the position of the front
rolls in relation to the bottom blade; variation of this
setting is made by adjusting the front roll:
1. Loosen the bolts securing the front roll brackets on
both sides of the machine.
2. Set the roll at the required height - raise the height
of cut by lowering the front roll and reverse the
procedure to reduce the height of cut. Check that
the setting is the same onboth sides of the
machine.
3. Tighten the bolts.
NOTE
The front roll should never be set so that the
bottom blade is pressing on the turf; this will
damage the spiral cutters, bottom blade and the
7.2

HANDLE (WALK BEHIND MACHINE ONLY) _______________________________

The height of the handle can be adjusted to suit the operator.
Always raise the handle when fitting and using the trailing
seat to give clearance for legs over undulating ground.
To adjust:
1. Slacken the clamp bolts
2. Move the handle to the required height.
3. Re-tighten the bolts.
en-28
turf