Stopping The Machine; Stopping The Engine - Ransomes Mastiff 91 Safety, Operation & Maintenance Manual

Before starting the engine, check or set the following points:
1. Check that the cylinder and landroll drive clutches
are disengaged and the brake is applied.
2. Turn the fuel tap B 'on' by positioning the lever
vertically downwards.
3. Move the choke control lever to the left for cold
starting.
NOTE
The choke may not be needed if the engine is
warm or the air temperature is high.
4. Ensure starter switch is turned to first position. This
only applies if using recoil starter to start engine.
5. Allow engine to warm up sufficiently before
returning choke to its running position.
6.6

STOPPING THE MACHINE ______________________________________________

1. Release the OPC and apply the brake.This is
equally important when moving forward or when
reversing.
2. Set the drive clutch lever (D) into the neutral (N)
position.
3. Set the cutting clutch lever (E) into the disengaged
position.
6.7

STOPPING THE ENGINE _______________________________________________

1. Turn starter switch (F) to the 'off' position and the engine will stop.
OPERATION 6
B
Cold Hot
E
D
F
en-25