Removing The Cutting Cylinder And Bottom Blade Assembly; Removing The Landroll Assembly - Ransomes Mastiff 91 Safety, Operation & Maintenance Manual

7.8

REMOVING THE CUTTING CYLINDER AND BOTTOM BLADE ASSEMBLY _______

1. Remove the chaincase and the cylinder drive
chain.
2. Tilt the machine back until it rests on the handles.
Ensure ithe machine is fully supported before
continuing
3. Remove the front roll by extracting the pivot studs
(A) and adjusting bolts (B) from both sides of the
machine.
4. Remove the three cylinder housing screws (C)
from both sides of the machine.
The complete cutting unit will then slide out. Re-assemble in reverse order.
7.9

REMOVING THE LANDROLL ASSEMBLY __________________________________

1. Places wedges under the side frames for support.
2. Remove the chain cover and landroll drive chain.
3. Disconnect brake cable by removing the split pin
and pin which connects the lower end of the cable
to the brake lever.
4. Remove the bolts securing the landroll bearing
housings (D) at both sides of the machine.
The landroll assembly will then slide out.
Re-assemble in reverse order
ADJUSTMENTS 7
en-31