Making Call Type Settings; Making Sip Settings - Panasonic KX-VC1600SX User Manual

Contacts and Settings
Note
•
The changed port number will be displayed
on the unit information screen (Page 87).
"H.245": Enter the initial port number for H.245
(5500–5580) (default: 5500).
Note
•
For the following items, a number will be
automatically added to the initial port
number that you enter. The total number
indicates the range and values of available
port numbers for the items.
–
"RTP and RTCP for Audio"
–
"RTP and RTCP for Video"
–
"Camera Control"
–
"RTP and RTCP for Video (Sub)"
–
"BFCP"
–
"H.245"
3.
Press [G].
•
A dialogue box to confirm the saving of settings
is displayed.
4.
Use [ ][ ] to select "Yes" and press [ENTER].
•
The administrator menu screen is displayed.

Making Call Type Settings

1.
Select "Call Type Settings" and press [ENTER].
•
The call type settings screen is displayed.
2.
Use [ ][ ] to select the following items for input:
"SIP": Use [ ][
"OFF".
Note
•
When "OFF" is selected, you cannot use a
SIP server even if "ON" is set to "SIP
Server" (Page 118).
•
If the other party is using the KX-VC300/
KX-VC600 with a software version older
than 3.00 (not including 3.00), you cannot
make a video conference call using H.323.
You must select "ON".
"H.323": Use [ ][
"OFF".
Note
•
When "OFF" is selected, you cannot use a
gatekeeper and H.460 even if "ON" is
118 User Manual
] to select "ON" (default) or
] to select "ON" (default) or
selected for "Gatekeeper" and "H.
460" (Page 119).
"Priority for connection mode": Press [ENTER]
and use [ ][ ] to select "IP Mode
(SIP)" (default), "IP Mode (H.323)", or "NAT
Traversal Mode".
Note
•
The communication type selected here will
be reflected onto the device's settings such
as its displayed contents and default
connection mode values for making calls.
3.
Press [G].
•
A dialogue box to confirm the saving of settings
is displayed.
4.
Use [ ][ ] to select "Yes" and press [ENTER].
•
The administrator menu screen is displayed.

Making SIP Settings

When using a SIP server over an intranet, video
conference calls can be made using SIP URIs (SIP user
name@SIP domain name).
Note
•
These settings can only be made when "SIP"
is set to "ON" on the call type settings screen.
•
Video conference calls to an MCU or a
non-Panasonic video conference system
through a SIP server using a SIP URI are not
guaranteed.
•
When connecting to an MCU by entering the
MCU's conference room number@IP address,
"SIP Server" and "Gatekeeper" (Page 120)
must be set to "OFF".
•
If video conference calls cannot be made
because there is a problem with the SIP server,
the SIP settings are incorrect (on the server, or
on the unit), etc., "Not registered" will be
displayed on the Home screen instead of the
SIP user name. In this case, you cannot make
calls using either IP addresses or SIP. Contact
your network administrator.
1.
Select "SIP Settings" and press [ENTER].
•
The SIP setting screen is displayed.
2.
Use [ ][ ] to select the following items for input:
"SIP Server": Use [
"OFF" (default).
][ ] to select "ON" or
Document Version 2015-03