Decorative Front Finishing - Heat & Glo COSMO42-IFT Installation Manual

D. Decorative Front Finishing
WARNING! Risk of Fire! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of deco-
rative fronts that may be used.
Overlap Fit - CFT and Martini Decorative Fronts
(0 Inches to 1 Inch Thick Finishing Material)
Both the CFT and Martini decorative fronts are designed
to overlap finish materials 0 inches to 1 inch thick. See
Figure 10.7 and Figure 10.8.
NOTICE: This one inch maximum not only includes the
decorative finish materials (marble, tile, slate, etc) but
also the mortar or adhesive used to attach the decorative
finish material.
The non-combustible finish material can be installed up to
the fireplace opening.
FRONT FACE OF FIREPLACE
DECORATIVE FRONT
Finishing materials 1 inch maximum thick.
Stop finishing material flush with opening.
Figure 10.7 Overlap Fit Decorative Front
(CFT and Martini Decorative Fronts)
Heat & Glo • COSMO42-IFT, COSMO32-IFT Installation Manual • 2491-980 Rev. C • 11/17
1 IN. MAX.
FINISHING MATERIAL
(TOP EDGE)
DRYWALL OR
EQUIVALENT (1/2 IN.)
Figure 10.8 Overlap Fit Method
(CFT and Martini Decorative Fronts)
FACTORY-INSTALLED
NON-COMBUSTIBLE BOARD
NON-COMBUSTIBLE
FINISHING MATERIAL
0 - 1 IN. THICK
CFT
DECORATIVE
FRONT SHOWN
NON-COMBUSTIBLE
FINISHING MATERIAL
0 - 1 IN. THICK
57