Table of Contents
Advertisement
Section 9: Installing the Accessories
H38ST Installing the Logs and Embers
STEP 1: Place Logs' "A" on Left & Right stands.
LOG A
STEP 2: Place Logs' "B" as shown, in front of Right-hand "A", and
behind left-hand "b".
LOG B
STEP 3: Log Installation. (Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
LOG C
STEP 4: completed Installation.
LOG D
INSTALLING THE EMBER MATERIAL the ember material is
supplied in two packages. Place the material evenly, forward of
both Log stands, under logs 'A' and 'B', also forward from Logs
'C' & 'D'. Refer to figure 25b. Ensure the burner holes are free of
ember material after placing the embers.
xg0227 - 112718
LOG A
figure 22.c
LOG B
figure 22.d
LOG C
figure 22.e
LOG D
figure 22.f
Installing the Firestones or optional
Fireglass
The linear model fireplace is supplied with firestones. Remove the
door(s) as shown on page 24. Follow these instructions to ensure all
parts are removed or replaced as required. once the glass door(s) is
removed place the firestones randomly across the pan as described.
figure 21. spreading out firestones
figure 21.b Completed firestone installation
WARNING: this appliance is intended for use only with the included
Montigo burners and accessories. never install or add any additional
or alternative media, rock wool or other material in this appliance. the
use of additional or alternative materials may pose potential safety
hazards, damage to the appliance, and void manufacturer's warranty.
Installation
29
Advertisement
Table of Contents
