Section 9: Installing The Accessories; The Delray Square Universal Burner; Installing Glass Media; Installing The Speckled Stone Media - Montigo DelRay Square DRSQ34NI Installation & Maintenance Manual

Section 9: Installing the Accessories

The DelRay Square Universal burner
The burner for the DelRay Square has been developed in away that equally supports contemporary and traditional scenes without the need for a
burner swap.

Installing glass media

Optional fireglass may be purchased from the dealer. Remove the Door
as shown in the previous Instruction. Once the glass door is removed
place the firestones randomly across the pan and the burners.
NOTE: ONLY COVER THE BURNER WITH ONE LAYER OF FIRESTONES
OR FIREGLASS.
DRSQ38 only use 4.5lb of firestones
Neon Embers Pull it apart with your fingers to avoid tangled
chunks. Place them on top of where the flames are located. The
neon embers should be barely visible when the flame is not lit.
Figure 24.ddd Completed ember install
Installing the speckled stone media
Optional speckled stone media may be purchased from the dealer.
Remove the Door as shown in the previous Instruction. Once the
glass door is removed place the firestones randomly across the pan
and the burners.
Note: Only cover the burner with one layer.
40
Do not attempt to light the fireplace without media placed on the
media tray. This can lead to delayed ignition.
IGNITION WARNING
Do not attempt to light the fireplace
with no media OR the incorrect
amount of media placed in the tray.
This could result in the fireplace not
lighting or delayed ignition taking
place.
WARNING
Ceramic chips can be broken up and placed in between the stones
providing they dont interfere with the burner ports.
Figure 24.dd Completed ceramic chip installation
Figure 21.c Completed Speckled Stone installation
Installation
Figure 24.b Completed firestone installation
XG0230 - 052020