Procedure 7.12 - Replacing A Speed Sensor Assembly - Precor EFX5.31 Instruction Manual

Procedure 7.12 - Replacing a Speed Sensor Assembly

Procedure
1. Set the on/off switch in the "off" position, then unplug the power cord from the wall outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the access panel, top, left and right cover sections as described in Procedure 7.1.
3. Remove the snap on cover from the lower PCA.
4. Disconnect the speed sensor cable from the J8 connector on the lower PCA. See Diagram
6.5.
5. Unsnap the speed sensor from the speed sensor bracket and remove the speed sensor.
See Diagram 7.9.
Diagram 7.9- Speed Sensor
6. Snap the replacement speed sensor into the speed sensor bracket. See Diagram 7.9.
7. Reconnect the speed sensor cable to the J8 connector on the lower PCA.
8. Replace the snap on cover on the lower PCA.
9. Re-install the left, right, top and access panel cover sections as described in Procedure 7.1.
10. Check the operation of the EFX per Section Four.
Speed Sensor
Bracket
Speed Sensor