Procedure 7.26 - Replacing a Lift Motor
1.
Set the on/off switch in the "off" position. Remove the A.C. line cord from the A.C. outlet.
2.
Remove the upper and lower front covers per Procedure 7.21.
3.
Remove the bolts that fasten the upper end of the ramp to the lift motor yoke. See Diagram
7.15.
4.
Carefully, draw the lift motor yoke out of the ramp and lay the ramp down against the frame.
5.
Disconnect the lift motor connector and remove the screw that retains the lift motor frame
ground. See Diagram 7.28.
Diagram 7.28 - Lift Motor Mounting
Lower Lift Motor
Mounting Hardware
Frame Ground
6.
Disconnect the lift motor cable connector.
7.
Remove the nut and bolt that fasten the lower end of the lift motor to the frame.