Power Connector Cable - HP 15 TouchSmart Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
● Keyboard (see
● Top cover (see
● Display (see
To remove the power connector cable:
1. Position the computer upright.
2. Disconnect the power connector cable (1) from the system board.
3. Release the power connector cable from the clips (2) built into the chassis.
4. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Battery on page 31), and then remove the following components:
Keyboard on page 35)
Top cover on page 43)
Display assembly on page 66)
Component replacement procedures
Spare part number
749647-001
55