Operational Parameters; Default Table - Symbol MINISCAN MSXX04 Integration Manual

10 - 2 Symbol MiniScan MSXX04 Series Integration Guide

Operational Parameters

MiniScan scanners are shipped with the default settings shown in
are stored in non-volatile memory and are preserved even when the scanner is powered down.
There are two ways to change the default values:
•
Scan the appropriate bar codes in this chapter. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the scanner's serial port using Symbol's Simple Serial Interface (SSI). Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the Simple Serial Interface (SSI) Programmer's
Guide for detailed instructions for changing parameters using this method.

Default Table

Table 10-1 lists the defaults for all parameters, and the page number each parameter appears on. To change any
option, scan the appropriate bar code(s).
Default Table
Table 10-1
Parameter
Set Default Parameter
Scanning Options
Beeper Volume
Beeper Tone
Beeper Frequency Adjustment
Laser On Time
Scan Angle
(MS1204FZY and MS954 only)
Power Mode
Trigger Mode
Scanning Mode (MS2204,
MS2204VHD, and MS3204 only)
Aiming Mode
Raster Height (MS2204, MS2204VHD,
and MS3204-I000 only)
Raster Expansion Rate (MS2204,
MS2204VHD, and MS3204-I000 only)
Table 10-1 on page
Set All Defaults
Parameter
Number
All Defaults
8Ch High Volume
91h High Frequency
F07 91h 2500 Hz
88h 3.0 sec: MS954
5.0 sec: MS2204; MS2204VHD;
MS3204
Wide
BFh
80h Low Power
8Ah Level
8Dh Smart Raster
F0h 7Eh Disabled
E4h 15
E5h 11
10-2. These default values
bar code on page 10-8.
Default
Number
10-8
10-10
10-11
10-11
10-12
10-12
10-13
10-14
10-15
10-16
10-17
10-17
Page