Table of Contents
Advertisement
Chapter 5
Programming
Operational Parameters
The LS 6000i is shipped with the settings shown in the
Table 5-1 beginning on page
5-2. These default values
are stored in non-volatile memory and are preserved
even when the scanner is powered down. You can
change these default values by scanning the
appropriate bar codes included in this manual. These
new values replace the standard default values in
memory. The default parameter values can be recalled
by scanning the
SET ALL DEFAULTS bar code on page
5-10.
If you are using a Synapse cable, your host is
autodetected, so no host bar codes need to be scanned.
If not, you must select a terminal type even if the default
parameters suit your needs. The scanner automatically
5-1
Advertisement
Table of Contents
