Table of Contents
Advertisement
Chapter 5
Parameter Menus
Operational Parameters
The LS 4000P is shipped with the settings shown in the Default Table on page 5-2. These
default values are stored in non-volatile memory and are preserved even when the scanner is
powered down. You can change these default values by scanning the appropriate bar codes
included in this chapter. These new values replace the standard default values in memory. The
default parameter values can be recalled by scanning the SET ALL DEFAULTS bar code on
page 5-8, then either the SET PC KEYBOARD WEDGE DEFAULTS bar code on page 5-93
or the SET SPANISH KEYBOARD WEDGE DEFAULTS bar code on page 5-101.
Even if the default parameters suit your needs, you must still select a terminal type if the
scanner is connected to a standard RS-232C. After you hear the power-up beeps, select the
proper port from the choices on page 5-11.
5-1
Advertisement
Table of Contents
