Beeper Tone
Parameter # 91h
To select a decode beep frequency (tone), scan the appropriate bar code.
Beeper Frequency Adjustment
Parameter # F0h 91H
This parameter adjusts the frequency of the high beeper tone from the nominal 2500 Hz to another frequency
matching the resonances of the installation. It is programmable in
10 Hz increments from 1220 Hz to 3770 Hz.
To increase the frequency, scan the bar code below, then scan three numeric bar codes beginning on
that correspond to the desired frequency adjustment divided by 10. For example, to set the frequency to 3000 Hz
(an increase of 500 Hz), scan numeric bar codes 0, 5, 0, corresponding to 50, or (500/10).
To decrease the frequency, scan the bar code below, then scan three numeric bar codes beginning on
10-111
that correspond to the value (256 - desired adjustment/10). For example, to set the frequency to 2000 Hz (a
decrease of 500 Hz), scan numeric bar codes 2, 0, 6, corresponding to 206, or (256 - 500/10).
Low Frequency
(02h)
Medium Frequency
(01h)
*High Frequency
(00h)
Beeper Frequency Adjustment
Parameter Menus 10 - 11
page 10-111
page