Event Reporting; Decode Event - Symbol MINISCAN MSXX04 Integration Manual

Event Reporting

The host can request the decoder to provide certain information (events) relative to the decoder's behavior. Enable
or disable the events listed in
number format for these parameters follows those shown in the Simple Serial Interface (SSI) Programmer's Guide
for parameters numbered 256 or higher.
Event Codes
Table 10-3
Event Class

Decode Event

Boot Up Event
Parameter Event
Decode Event
Parameter # F0h 00h
When enabled, the scanner sends a message to the host whenever a bar code is successfully decoded. When
disabled, no message is sent.
Table 10-3 by scanning the appropriate bar codes on the following pages. Parameter
Event
Non parameter decode
System power-up
Parameter entry error
Parameter stored
Defaults set (and parameter event is enabled by default)
Number expected
Enable
(01h)
*Disable
(00h)
Parameter Menus 10 - 99
Code Reported
01h
03h
07h
08h
0Ah
0Fh