Imaging Sequence Examples; Errors While Imaging; Imager Preferences Parameter Defaults - Motorola Symbol MS4404 Integration Manual

7 - 2 Symbol MS4404/MS4407 Integration Guide

Imaging Sequence Examples

In most cases capturing one bar code sets the parameter value. For example, to disable the decode aiming
pattern, capture the Disable Decode Aiming Pattern bar code listed under
For systems that use a beeper and LED, a fast warble beep sounds and the LED lights, signifying a successful
parameter entry.
Other parameters, such as Crop to Pixel Address, require capturing several bar codes. See these parameter
descriptions for this procedure.

Errors While Imaging

Unless otherwise specified, to correct an error during an imaging sequence, just re-capture the correct parameter.

Imager Preferences Parameter Defaults

Table 7-1 lists defaults for imager preferences parameters. To change any option, capture the appropriate bar
code(s) provided in
NOTE See
default parameters.
Imager Preferences Default Table
Table 7-1
Parameter
Imaging Options
Focus Mode
Decoding Autoexposure
Decoding Illumination
Decode Aiming Pattern
DPM Scanning
Image Capture Autoexposure
Image Capture Illumination
Gain
Exposure Time
LED Illumination
Snapshot Mode Timeout
Imager Preferences on page
Appendix A, Standard Defaults
Parameter Number
F0h A6h
F0h 29h
F0h 2Ah
F0h 32h
F1h 09h
F0h 68h
F0h 69h
F4h F0h A7h
F4h F0h 38h
F0h ADh
F0h 43h
7-4.
for all user preferences, hosts, symbologies, and miscellaneous
Far Focus
Note: The default value
for DPM digital scanners
is Near Focus.
Enable
Enable
Enable
Enable
Enable
Enable
100
10 ms
External LED Illumination
0 (30 seconds)
Decode Aiming Pattern on page
Default Page Number
7-5
7-6
7-6
7-7
7-8
7-9
7-9
7-10
7-11
7-12
7-12
7-7.