Code 11; Set Lengths For Code 11 - Motorola Symbol MS4404 Integration Manual

11 - 36 Symbol MS4404/MS4407 Integration Guide

Code 11

Code 11
Parameter # 0Ah
To enable or disable Code 11, capture the appropriate bar code below.
Enable Code 11

Set Lengths for Code 11

Parameter # L1 = 1Ch, L2 = 1Dh
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific
range.
•
One Discrete Length - Select this option to decode only Code 11 symbols containing a selected length.
Select the length using the numeric bar codes in
only Code 11 symbols with 14 characters, capture Code 11 - One Discrete Length, then capture 1 followed
by 4. To correct an error or to change the selection, capture Cancel on
•
Two Discrete Lengths - Select this option to decode only Code 11 symbols containing either of two
selected lengths. Select lengths using the numeric bar codes in
example, to decode only those Code 11 symbols containing either 2 or 14 characters, select Code 11 - Two
Discrete Lengths, then capture 0, 2, 1, and then 4. To correct an error or to change the selection,
capture Cancel on
•
Length Within Range - Select this option to decode a Code 11 symbol with a specific length range.
Select lengths using numeric bar codes in
Code 11 symbols containing between 4 and 12 characters, first capture Code 11 - Length Within Range.
Then capture 0, 4, 1, and 2 (single digit numbers must always be preceded by a leading zero). To correct an
error or change the selection, capture Cancel on
•
Any Length - Capture this option to decode Code 11 symbols containing any number of characters within
the imager capability.
(01h)
page D-3.
*
Disable Code 11
Appendix D, Numeric Bar
Appendix D, Numeric Bar
Appendix D, Numeric Bar Codes.
page D-3.
(00h)
Codes. For example, to decode
page D-3.
Codes. For
For example, to decode