Chapter 3 User Preferences; Introduction; Scanning Sequence Examples; Errors While Scanning - Motorola CS3000 Manual

CHAPTER 3 USER PREFERENCES

Introduction

This chapter describes each user preference feature and provides the programming bar codes for selecting
these features for the scanner.
The scanner ships with the settings shown in the
Appendix A, Standard Default Parameters
default values suit the requirements, programming is not necessary. To change these values, scan a single bar
code or a short bar code sequence. After scanning
stored in non-volatile memory and are preserved when the scanner powers down.
To return all features to their default values, scan the
the programming bar code menus, default values are indicated with asterisks (

Scanning Sequence Examples

In most cases, scan only one bar code to set a parameter value. For example, to set the beeper tone to high,
scan the High Frequency (beeper tone) bar code under
warble beep and the LED turns green, indicating a successful parameter entry.
Other parameters, such as Data Transmission Formats, require scanning several bar codes. See the
parameter description for this procedure.

Errors While Scanning

Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.
for all host device and miscellaneous scanner defaults). If the
*
*
Indicates Default High Frequency
User Preferences Default Table on page 3-2
Save Configuration on page
Reset Factory Defaults
Feature/Option
Beeper Tone on page
(also see
3-22, the new settings are
bar code on page 3-4. Throughout
*
).
3-9. The scanner issues a fast