Serial Host Parameters - Motorola Symbol MS4404 Integration Manual

Serial Host Parameters

Various serial hosts are set up with their own parameter default settings
Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron sets the defaults listed
below.
Terminal Specific Serial
Table 9-2
Parameter
Transmit Code ID Yes
Data Transmission Data/Suffix
Format
Suffix CR (1013)
Baud Rate 9600
Parity Even
Hardware RTS/CTS
Handshaking Option 3
Software Handshaking None
Serial Response 9.9 Sec.
Time-out
Stop Bit Select One
ASCII Format 8-Bit
Beep On <BEL> Disable
RTS Line State High
Prefix None
*In the Nixdorf Mode B, if CTS is Low, imaging is disabled. When CTS is High, you can capture bar codes.
**If you select Nixdorf Mode B and the imager is not connected to the proper host, it may appear unable to
decode. If this happens, select a different serial host type within 5 seconds of cycling power to the imager.
Selecting ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron enables
the transmission of code ID characters listed in
are separate from the Transmit Code ID feature. Do not enable the Transmit Code ID feature for these terminals.
Wincor-Nixdorf
ICL Fujitsu
Yes Yes
Data/Suffix Data/Suffix
CR (1013) CR (1013)
9600 9600
None Odd
None RTS/CTS
Option 3
None None
2 Sec. 9.9 Sec.
One One
8-Bit 8-Bit
Disable Disable
Low Low
None None
Table
Symbol MS4404 - RS-232 (Serial) Interface
(Table
Wincor-Nixdorf
Mode
Mode A
B/OPOS/JPOS
Yes
Data/Suffix
CR (1013)
9600
Odd
RTS/CTS Option
3
None
9.9 Sec.
One
8-Bit
Disable
Low = No data to
send
None
9-3. These code ID characters are not programmable and
9-2). Selecting standard, ICL,
Olivetti Omron
Yes Yes
Prefix/Data/ Data/Suffix
Suffix
ETX (1002) CR (1013)
9600 9600
Even None
None None
Ack/Nak None
9.9 Sec. 9.9 Sec.
One One
7-Bit 8-Bit
Disable Disable
Low High
STX (1003) None
9 - 3