11 - 14 Symbol MS4404/MS4407 Integration Guide
UPC/EAN/JAN Supplemental Redundancy
Parameter # 50h
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a
symbol without supplementals is decoded before transmission. The range is from two to thirty times. Five or above
is recommended when decoding a mix of UPC/EAN/JAN symbols with and without supplementals, and the
autodiscriminate option is selected. The default is set at 10.
Capture the bar code below to set a decode redundancy value. Next, capture two numeric bar codes in
D, Numeric Bar
Codes. Single digit numbers must have a leading zero. To correct an error or change a selection,
capture Cancel on
UPC/EAN/JAN Supplemental Redundancy
Transmit UPC-A Check Digit
Parameter # 28h
The check digit is the last character of the symbol used to verify the integrity of the data. Capture the appropriate
bar code below to transmit the bar code data with or without the UPC-A check digit. It is always verified to
guarantee the integrity of the data.
*
Transmit UPC-A Check Digit
page
D-3.
(01h)
Do Not Transmit UPC-A Check Digit
(00h)
Appendix