Conversion From Ng To Lp - Regency L390E Owners & Installation Manual

Gas insert

Hide thumbs Also See for L390E:

Owner's manual (56 pages)

Table Of Contents

Table of Contents

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION!

This conversion kit shall be installed by a qualiﬁ ed service agency in

accordance with the manufacturer's instructions and all applicable codes

and requirements of the authority having jurisdiction. If these instructions

is not followed exactly, a ﬁ re, explosion or production of carbon monoxide

may result causing property damage, personal injury or loss of life. The

qualiﬁ ed service agency is responsible for the proper installation of this

kit. The installation is not proper and complete until the operation of the

converted appliance is checked as speciﬁ ed in the manufacturer's instruc-

tions supplied with the kit.

Conversion Kit 396-972 includes:

911-011

Stepper Motor LP for 885 SIT

904-947

Oriﬁ ce #53

918-590

Decal - Conversion to LP

908-528

Label Propane

Before you begin:

Shut off the gas supply to the unit.

Disconnect all electrical supply to the unit.

Always let the appliance cool to room temperature before servicing.

1) Remove the left side control cover.

The valve in the L390E is attached using 2 screws and 2 hooks located

below the valve. Loosening the screws part way and lift the valve to

disengage the hooks.

The valve will then hinge outward allowing access to the components

and pressure taps located on the top of the valve without completely

removing the valve.

2) Loosen both screws at the top of the valve about ½ way out. Lift the

valve body and lean outward. The Valve Brackets will rest open as

shown on the right.

L390E / HZI390E Direct Vent Gas Insert