Final Installation - Maytag MAH4000AWQ NEPTUNE Installation Instructions Manual

FINAL INSTALLATION CHECKLIST
Instruction and Installation Kit have been removed from tub.
Shipping bolts and straps have been removed.
Vinyl feet have been installed.
Washer is plugged into electrical outlet and is properly grounded.
Water is turned on and checked for leaks at faucet and water valve connections.
Drain hose is properly located into drain facility and is not kinked.
Washer has been properly leveled. All legs should be firmly on the floor and lock nuts
MUST be tightened.
Washer fills properly on all temperature selections.
Test for proper operation by running the washer though a complete cycle.
1. Select Cotton/Sturdy, Hot/Cold and Max Extract. Make sure the Extra Rinse
option is not selected.
2. Set the timer into the Heavy-Normal-Light wash band and press the Start/Stop
button.
3. Verify the washer is filling from the hot water valve.
4. Verify the washer stops filling
5. Set the timer into the Rinse 3 Increment and press the Start/Stop button to restart
the washer.
6. Verify the washer is filling from the cold valve.
7. Verify the washer stops filling.
8. Advance the timer one increment into Spin.
9. Verify the washer spins. This will take several minutes as the door needs to lock
and distribute the load.
10. Pull on the door to make sure it has locked.
11. Reset washer to start position.