Installation Instructions - Maytag MAT23CS Instructions Manual

10. While the internal connector is still accessible, perform an
Earthing Continuity Test:
A current of at least 10 A, derived from a source having a
no-load voltage not exceeding 12 V (AC or DC), is passed
between:

The grounding pin or earthing contact of the plug, and

The grounding conductor of the appliance side connector
(female);
The voltage drop is measured and the resistance is calculated
and shall not exceed 0.2 Ω.
If not found to be properly grounded, contact the
manufacturer. Do not connect to the power supply.
Appliance Side
Grounding
Conductor
Ground Continuity
Test Location 1
11. Once ground continuity is confirmed, rotate the fully
assembled strain relief bracket and insert it into the opening
in the back panel with the connector side facing inward.
The installer shall ensure:
a) That the screw bore is aligned with the back panel screw
orifice.
b) The lip of the strain relief bracket is on the external side of
the metal back panel.
Screw
Bore
12. Insert the retaining screw from step 1 and secure the cord set
to the back panel.
The cord assembly shall not be able to be pushed inward,
pulled outward, or twisted in any fashion that puts stress on
the internal conductors. If not secured, revisit sections 7-11
and ensure proper installation.
12
IEC Plug Type CEE 7/7
Type F&E Compatible
IEC Plug Type I
(Australia)
Plug
Grounding
Pin/Conductor
IEC Plug
Type G
Ground Continuity
Test Location 2
Strain Relief
Bracket Lip

INSTALLATION INSTRUCTIONS

WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
1. Move washer to within 1.2 m (4 ft) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
1.2 m
1,2 m
(48")
(48")
2. To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back
and place on cardboard supports. Remove shipping base.
Set washer upright.
IMPORTANT: Removing shipping base is necessary for proper
operation. If your washer includes a sound shield, please refer
to the instructions included with the sound shield to install it
at this time.
NOTE: Keep shipping base in case you need to move washer
later.
3. Remove tape from washer lid, open lid, and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Tray must be removed prior to plugging the washer
into an outlet. Keep tray in case you need to move washer
later.