Door Reversal - Maytag MAH4000AWQ NEPTUNE Installation Instructions Manual

FLOOR DRAIN INSTALLATION
If a floor drain is used, route the drain hose through the drain hose strap (as shown) before
routing to the drain. For installations where the drain hose cannot be conveniently elevated
to 24", the drain hose must be supported by the drain hose strap on the back of the washer.
DOOR REVERSAL
Clothes washer door swing direction can be successfully changed using the following proce-
dure:
1. Swing door fully open and support it while removing four hinge screws (which hold
hinges to door assembly).
2. Set door aside and transfer four color matched door screws to the opposite side of the
door assembly.
3. Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to
cabinet (opposite side).
4. Remove hinge and bracket from cabinet by moving them up and down to a position where
they are related.
5. Install hinge and bracket in swapped locations and drive screws to attach them securely to
the cabinet.
6. Compare top hinge and top bracket to bottom hinge and bottom bracket for correct
assembly position.
7. Repeat procedures 4 - 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8. Support door in fully open position on hinge side and drive four screws to securely attach
hinges to door assembly.
9. Close door and check to see that clothes washer operates properly.