Maytag MAH4000AWQ NEPTUNE Installation Instructions Manual page 9

2. Connect inlet hoses to water supply using screen washer at faucet connections.
3. Plug power cord into a grounded 120 volt 60 Hz approved electrical service protected by
a 15 amp fuse or comparable circuit breaker. This washer is grounded through the third
prong of the power cord when plugged into a three prong grounded receptacle.
NOTE: To prevent the possibility of electrical shock, this washer (as is the case with
other electrical appliances) must be adequately grounded.
It is the responsibility of the installer to assure the washer is adequately grounded at the point
of installation taking into consideration the local conditions, codes and requirements.
4. Slide washer into position. Do not kink drain hose. NOTE: the washer must be lev-
eled on all 4 edges. To properly level a machine, the top cover and the front panel must
be securely fastened. A carpenter's level should be used on all 4 edges of the top cover.
5. Slide the washer out of position to either raise or lower the leveling leg required to level
or stabilize the washer securely on all four legs. Slide the washer back into position to con-
firm levelness and solidness to the floor. When satisfied the washer is level, tighten the
locking nuts up against the base of the washer. This will secure the leveling legs in place.