Download Print this page

Final Installation Checklist - Maytag Neptune MAH5500BWW Installation Instructions Manual

High-efficiency washer
Hide thumbs Also See for Neptune MAH5500BWW:

Advertisement

FINAL INSTALLATIONCHECKLIST
[]
Instruction and Installation Kit have been removed from tub.
Shipping straps have been removed.
[]
Washer is plugged into electrical outlet and is properly grounded.
r-q Water hoses are connected to the faucets with inlet screens and washers.
___q W ater is turned on and checked for leaks at faucet and water valve connections.
_- Drain hose is properly located into drain facility and is not collapsed or damaged.
[]
Washer has been properly leveled. All legs should be firmly on the floor and leveling leg lock nuts
MUST be tightened.
Washer fills properly on all temperature selections.
Test for proper operation by running the washer through a complete cycle.
MAH5500B
1. Press "Cotton/Sturdy"to turn the machineon.
2. Arrow up to select "Hot/Cold"wash/rinse temperature.
3. Press "Start/Pause".
4. Verify the washer is filling with hot water.
5. Verity the washer stops filling.
6. Press "Start/Pause"to pause the cycle.
7. Select "Rinse";press "Start/Pause"to resumethe cycle.
8, Verify the washer is fillingwith coldwater.
9. Verify the washer stops filling.
10. Press "Start/Pause"again;select "Spin"; press "Start/Pause"to resume the cycle.
11. Verifythe washer spins. This will take severalminutes,the machinewill first drain and distributethe clothes.
12. Pull on the door to make sure that it has locked.
13. Allow the cycle to finish, verify that the door has unlocked at the end of the cycle.
MAH7500
1. Press"Home";select "Cotton/Sturdy";"HotWash/Cold" Rinse",
2. Press "StartPause".
3. Verify the washer is filling with hot water.
4. Verify the washer stops filling.
5. Press "Start/Pause".
6, Press "Off".
7. Press "Home";select "More Cycles" then select "Cold Rinse & Spin"; press "Start/Pause"to resume the cycle.
8. Verify the washer is filling with cold water.
9. Verifythe washerstops filling.
10. Press "Start/Pause".
11. Press "Off".
12. Press "Home";select "More Cycles", then select "Spin";press "Start/Pause"to resume the cycle.
13. Verify the washer spins. This will take several minutes, the machine will first drain and distribute the clothes.
14. Pull on the door to make sure it has locked.
15. Allow the cycle to finish, verify that the door has unlocked at the end of the cycle.
Make any corrections necessary to properly complete the installation.
Page4

Advertisement

loading