Securing Proforce Debris Blower To Tow Vehicle - Toro ProForce 44538 Service Manual

Securing ProForce Debris Blower to Tow Vehicle

While operating or servicing the ProForce Debris Blow-
er, make sure that blower is properly secured to tow ve-
hicle (Fig. 1). Refer to your Operator's Manual for the
correct procedure for attaching blower to tow vehicle.
Jacking Instructions
CAUTION
When changing tires or performing other ser-
vice, use suitable hoists and jacks to support
the ProForce Debris Blower. Make sure ma-
chine is parked on a solid level surface such as
a concrete floor. Always chock or block wheels.
Use suitable jack stands to support the raised
machine. If the machine is not properly sup-
ported by jack stands, the machine may move
or fall, which may result in personal injury.
1. Position ProForce Debris Blower on a level surface
with blower attached to tow vehicle. Engage tow vehicle
parking brake, stop engine and remove key from the
ignition switch. Make sure that blower engine is off.
Chock blower wheels to prevent the machine from mo-
ving.
2. Position jack securely under the main frame of the
blower (Fig. 2). Do not use the axle as a jacking point.
3. Carefully jack machine off the ground.
4. Position jack stands under the main frame to support
the ProForce Debris Blower.
ProForce Debris Blower
2
1
1. Tow vehicle hitch
2. Hitch pin
1. Wheel
Page 1 - - 5
3
Figure 1
3. Hairpin clip
2
1
Figure 2
2. Frame jacking point
Safety