Toro ProForce 44538 Service Manual page 79

Wheel Removal (Fig. 2)
1. Have ProForce Debris Blower attached to tow ve-
hicle and park machines on a level surface. Engage ve-
hicle parking brake, stop engine and remove key from
the ignition switch. Make sure that blower engine is off.
Chock wheels to prevent movement of either machine.
2. To prevent unexpected blower operation, disconnect
the negative battery cable from the battery terminal (see
Battery Service in the Service and Repairs section of
Chapter 4 -- Electrical System). Position disconnected
negative cable away from the negative battery terminal.
3. Loosen but do not remove four (4) lug nuts that se-
cure wheel to be removed.
4. Jack or hoist ProForce blower from ground and sup-
port raised machine with jack stands (see Operator's
Manual and Jacking Instructions in Chapter 1 -- Safety).
5. Remove lug nuts and pull wheel from machine wheel
hub.
ProForce Debris Blower
Wheel Installation (Fig. 2)
1. Position wheel to wheel hub on raised machine.
2. Secure wheel to ProForce blower with four (4) lug
nuts.
Failure to maintain proper lug nut torque could
result in failure or loss of wheel and may result in
personal injury.
3. Lower machine to ground. Alternately torque lug
nuts from 70 to 90 ft- -lb (95 to 122 N- -m).
4. Connect negative battery cable to negative battery
terminal. Tighten nut that secures battery cable from 10
to 15 ft- -lb (14 to 20 N- -m). Make sure that battery cover
is secured.
Rev. B
Page 6 - - 5
WARNING
Chassis