Toro ProForce 44538 Service Manual page 23

Fuel Tank Removal (Figs. 2 and 4)
1. Park machine on a level surface with the engine OFF.
Chock wheels to prevent machine from moving.
2. To prevent unexpected machine operation, discon-
nect the negative battery cable from the battery terminal
(see Battery Service in the Service and Repairs section
of Chapter 4 -- Electrical System). Position discon-
nected negative cable away from the negative battery
terminal.
3. Remove fuel from the fuel tank and into a suitable
container.
4. Note routing of fuel hoses for installation purposes.
Disconnect fuel hoses from fuel tank fittings. Plug fuel
hoses to prevent leakage or contaminant entry.
5. Remove fuel tank from machine using Figure 2 or 4
as a guide. Make sure to clean up any spilled fuel.
6. On machine with serial number above 310000000,
remove components from fuel tank as needed using
Figure 5 as a guide.
Fuel Tank Installation (Figs. 2 and 4)
1. On machine with serial number above 310000000,
install all removed components to fuel tank using Figure
5 as a guide.
2. Install fuel tank to machine using Figure 2 or 4 as a
guide.
3. Remove plugs placed in fuel hoses during fuel tank
removal. Connect fuel hoses to tank fittings and secure
with hose clamps.
4. Add fuel to tank and check for any fuel leaks.
5. Connect negative battery cable to negative battery
terminal. Tighten nut that secures battery cable from 10
to 15 ft- -lb (14 to 20 N- -m). Make sure that battery cover
is secured.
ProForce Debris Blower
1. Engine blower housing
2. Fuel filter
SERIAL NUMBER ABOVE
310000000 SHOWN
1. Fuel tank assembly
2. Flange nut (4 used)
SERIAL
NUMBER
ABOVE
310000000
1. Fuel tank
2. Fuel tank cap
3. Grommet
4. Fuel gauge
Rev. B
Page 3 - - 7
3
1
Figure 3
3. Fuel filter inlet
1
Figure 4
3. Tank strap (2 used)
5
4
6
7
3
8
Figure 5
5. Rollover valve
6. Standpipe
7. Grommet
8. Bushing
2
3
2
2
1
Engine